Abstract
Examines the problems involved in mechanically lifting a cut piece of fabric from stacked layers, successfully separating the single piece, and transferring it to a precisely defined position. Grasping heads of four main types (or a combination) are commonly used: mechanical, pneumatic, adhesive and electrostatic. Describes experimental testing of mechanical heads operating with needles for different types of fabrics. Additional equipment (brushes on the edge of the cut fabric layer) always increased taking‐off reliability, as did additional pressure plates up to a certain mass.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal of Clothing Science and Technology
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
