Abstract
As vehicles become more intelligent for safety and convenience of drivers, IVN(In-Vehicle Network) requires high speed of transmission and hardware redundancy for safety. FlexRay was developed to replace Controller Area Network (CAN) protocol in chassis networking systems to provide mote transmission capacity and shorter real-time transmission delay. However, FlexRay has many related parameters such as base cycle and slot lengths to be determined in the design stage. To assist vehicle network designers in configurationg a FlexRay network, this paper presents automatic field bus exchange format (FIBEX) generation method for migration from CAN message format such as CANdb to FlexRay FIBEX format.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
