Abstract

This work has been focused to describe the development and implementation of an automated system for measurement and characterization of planar active arrays. This automated system is capable of reducing time and operative cost and it is based on multilayer hardware architecture and the control software. The motivation of this work is the calibration of one triangular active array panel of the Geodesic Antenna Array GEODA. The measurements and characterization are complicated and multipart tasks in the design, development and calibration of active antenna arrays. In this paper an automated system is presented supported by measurements and characterization of one planar active array.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.