Automated measurements of antilisterial activities of lactate and diacetate in ready-to-eat meat

Abstract

Standard procedures to enumerate Listeria organisms rely on plating food samples on selective agar media. The procedures are labor-intensive, and because of the limited sensitivity, pre-enrichment step is required for the detection of low numbers of the pathogen. In the present study, an automated rapid optic procedure and the standard procedure were used to determine the behavior of the pathogen in ready-to-eat (RTE) meat and to test the effect of antilisterial agents. Listeria monocytogenes strain Scott A or a six-strain mixture of Listeria was studied using lactate (2.5%), diacetate (0.2%) and their combination in beef bologna and in sterile beef emulsion. Samples stored for up to 60 days at 5 and 10 °C were tested at time intervals during storage. Using the plate count method, each of the salts caused a delay in growth of the pathogen, and the salt combination was most effective causing listeriostatic effects and decline in growth of the pathogen at 5 °C. High negative correlation ( r), ranging from 0.92 to 0.99, was obtained between the detection time (DT) recorded by the optic procedure (BioSys instrument) and cell numbers determined by the plate count procedure. The rapid (<24 h) optic procedure was reliable in assessing the efficacy of antimicrobials and in rapid detection of low levels of listeriae that are undetectable by direct plating procedure.