Austenite formation during intercritical annealing

Abstract

A systematic experimental study has been conducted on ferrite recrystallization and intercritical austenite formation for two low-carbon steels with chemical compositions typically used for dual-phase and transformation-induced plasticity (TRIP) steels. Different initial heating rates, holding temperatures, and times were applied to the materials to examine the ferrite recrystallization and austenite formation kinetics. An Avrami model was developed to describe the isothermal ferrite recrystallization behavior and was applied successfully to the nonisothermal conditions. It was found that the initial heating rate affects the isothermal austenite formation kinetics for both the hot-rolled and cold-rolled materials albeit the effect is more pronounced for the cold-rolled material. This can be attributed to the interaction between the ferrite recrystallization and austenite formation processes. Furthermore, it was found that the distribution of austenite phase is also affected by the ferrite recrystallization process. When ferrite recrystallization is completed before the austenite formation (i.e., under sufficiently slow heating rate conditions), austenite is to a large extent randomly distributed in the ferrite matrix. On the other hand, incomplete recrystallization of ferrite due to higher heating rates leads to the formation of banded austenite grains. It is proposed that this observation is characteristic of simultaneous recrystallization and austenite formation where moving ferrite grain boundaries do not provide suitable sites for austenite nucleation.