Austenite and ferrite grain sizes in interstitial free steel

Abstract

An oxidation method has been employed to reveal prior austenite grain boundaries in C–Mn and interstitial free (IF) steels. The ability of this technique to reveal prior austenite grain boundaries is assessed by comparing its results with those of an etching method applied on the C–Mn steel. Optimum conditions were established by trial and error. The conditions varied with different steels and with heat treatment temperature. In the IF steel rapid grain growth at high temperatures in the ferrite range made a significant contribution to the prevention of grain refinement through transformation. Attempts to obtain the smallest prior austenite grain size in the IF steel to assess the ability of the oxidation technique to reveal fine austenite grains led to an average austenite grain size of 80 μm in warm rolled samples after the shortest holding time at 950°C.MST/3203