Abstract

Auditory filter shapes were derived from notched-noise masking data at center frequencies of 8 kHz (for three spectrum levels, N0 = 20, 35, and 50 dB) and 10 kHz (N0 = 50 dB). In order to minimize variability due to earphone placement, insert earphones (Etymotic Research ER2) were used and individual earmolds were made for each subject. These earphones were designed to give a flat frequency response at the eardrum for frequencies up to 14 kHz. The filter shapes were derived under the assumption that a frequency-dependent attenuation was applied to all stimuli before reaching the filter; this attenuation function was estimated from the variation of absolute threshold with frequency for the three youngest normally hearing subjects in our experiments. At 8 kHz, the mean equivalent rectangular bandwidths (ERBs) of the filters derived from the individual data for three subjects were 677, 637, and 1011 Hz for N0 = 20, 35, and 50 dB, respectively. The filters at N0 = 50 dB were roughly symmetrical, while, at the lower spectrum levels, the low-frequency skirt was steeper than the high-frequency skirt. The mean ERB at 10 kHz was 957 Hz. At this frequency, the filters for two subjects were steeper on the high-frequency side than the low-frequency side, while the third subject showed a slight asymmetry in the opposite direction.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.