Abstract

A prototype Dynamic Spectrum Access (DSA) system is implemented, for ease of implementation, using the audio spectrum. In this setup, laptop PCs behave as two software defined radios (SDR), one a primary user (PU) and the other a secondary user (SU). The radios communicate digital information over the air, using the audio capabilities of standard soundcards. The PU, which is emulating the licensed user of an audio channel centered at 4 kHz, communicates using binary phase shift keying (BPSK) modulated data in periodic bursts. A cognitive radio (CR) based SU wishes to opportunistically occupy the PU channel during the inter-burst times, i.e. during the temporal ‘spectrum holes,’ while not interfering with the PU traffic. The PU link is implemented in MATLAB, while the SU is defined in GNU Radio with a separate Python control module defining its algorithm for spectrum sensing and hopping. The implementation of both communication links is described, as well as the initial performance evaluation of the preliminary system in terms of bit error rate performance of the PU with and without the presence of an active SU. The measured BER achieved for the best of the PU bursts with DSA was on the order of a few percent, just slightly higher than without DSA.

Full Text

Published Version

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.