Abstract
Attenuation factors in water have been measured by a narrow-beam technique in various portions of x-ray beams with nominal energies of 6 and 25 MV, with and without a wedge in the beam. The results were analyzed in terms of an attenuation coefficient mu for small water thicknesses and a beam-hardening coefficient eta that describes the change in attenuation per unit depth. The variation of mu within the field was significant, about 0.5% per centimeter at 6 MV and 0.8% per centimeter at 25 MV for open beams. The heavy wedge used in these experiments caused significant (about 10%) beam hardening at 6 MV, softened the beam somewhat at 25 MV, and increased the variation of mu within the field to 3%-5%. These effects should be taken into account in dose calculations, and correction factors can be designed based on the variation of mu with off-axis radius for open beams and with off-axis position for wedged beams. The experimental technique, based on two measurements with the beam going through a water tank with either 26- or 50-cm path length, was simple and highly reproducible. The beam hardening with depth in water, i.e., the value of eta, was readily determined but found to be clinically insignificant.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.