Attempts of B-site doped LaFeO3 oxygen carriers in high-moisture content biomass chemical looping gasification

Abstract

With the rapid development of anaerobic digestion engineering, the disposal and utilization of digestate are urgently required. Chemical looping gasification (CLG) technology provides potential for eliminate digestate and convert it into high-quality syngas. However, the application of conventional CLG is hindered by the high-moisture content of digestate. In order to decrease the energy consumption of dehydration, this work aims to optimize the CLG process by developing new oxygen carrier (OC) to enhance the transition of self-moisture of digestate. LaFeO3 was employed as the basic OC and Cr, Co, Cu were further doped on the B-site to form LaB0.5Fe0.5O3 (B = Cr, Co, Cu). H2O-TPD, OH/FTIR, NH3-Drifts, Raman, and XPS were employed to analyze the adsorption and dissociation of H2O by different OCs. Results indicated that LaFeO3 and LaB0.5Fe0.5O3 exhibited a synergistic effect with H2O, enabling adsorption of H2O at low temperatures and dissociation at high temperatures. In this case, it allows OC to capture H2O in the initial drying stage, then release H2O and OH at higher temperatures to participate in subsequent reactions, thus significantly increase the gasification performance. Fixed-bed CLG experiments were conducted to corroborate the characterization results. LaCu0.5Fe0.5O3 showcased the best gasification effect, achieving 81.83 % efficiency at a digestate moisture content of 40 %, surpassing LaFeO3 CLG by 5 %. Moreover, LaCu0.5Fe0.5O3 exhibited a noticeable catalytic effect and lowered the activation energy (E). Kinetic analysis revealed a 16 % reduction in E for LaCu0.5Fe0.5O3 CLG in comparison to LaFeO3 CLG.