Attainment of an exceptionally high strength in low-carbon steel along with modest ductility through a novel heat treatment route

Abstract

ABSTRACTOver the last few decades, the use of steel (the most significant structural engineering material) is facing a significant challenge due to its replacement by other materials (such as composites) possessing higher strength-to-weight ratio/specific strength. This necessitates further enhancement in the strength of steel. In particular, low-carbon steel, in the annealed condition, suffers from inherent problems of poor strength and discontinuous yielding. In this research work a novel heat treatment route of incomplete austenitisation-based cyclic ice-brine quenching has been adopted on low-carbon steel (AISI 1010 steel containing 0.1 wt.% C) without considering any costly alloying or thermo-mechanical treatment. Accordingly, exceptionally high strength (UTS = 1.7 GPa) and specific strength (226 MPa g−1cm3) are achieved after three cycles along with a modest ductility (% Elongation = 9). This is the highest strength reported so far for low-carbon steel containing 0.1 wt.% C. Yield point phenomenon is also eliminated. This is attributed to a novel microstructure consisting of highly sub-structured fine plate martensite crystals containing internal twin and dislocation tangles along with dispersion of nano-sized cementite particles and clusters of cementite particles.