Abstract
Cutter‐joints—During the past year, at the request of Dr. Church and Mr. Elges, I have conducted a number of experiments and tests on two methods, other than the one now used, of joining the sections and cutters of the sampler‐tubes. This work was carried out in the Mechanic Arts Shops and Civil Engineering Laboratory of the University of Nevada. The purpose of these experiments was to develop a joint between the aluminum tube and steel cutter that would make the replacement of the cutter possible in case of damage under conditions encountered in the field.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.