Atomization and surface heat transfer characteristics of cryogen spray cooling with expansion-chambered nozzles

Abstract

Cryogen spray cooling (CSC) is commonly applied in laser dermatology to protect the epidermis from thermal damage. Many efforts have attempted to improve the cooling capacity of CSC, among which the use of expansion-chambered nozzles is an effectively simple method with considerable potential. This study examined the influences of the expansion-chambered nozzle structure, including the ratios of inlet nozzle diameter to discharge nozzle diameter and of chamber diameter to discharge nozzle diameter on R134a and R404A spray cooling. Fifteen transparent expansion-chambered nozzles with the expansion chamber aspect ratio of 1.0, chamber diameter to discharge nozzle diameter ratios of 5.0–10.0, and inlet nozzle diameter to discharge nozzle diameter ratios of 0.6–1.4 were tested. The internal flow pattern inside the expansion chamber, external spray pattern, and surface heat transfer characteristics of cryogen spray using different nozzles, including the straight-tube nozzle, were investigated. The structure of the expansion chamber was found to have an important effect on the spray patterns and cooling characteristics. The spray radius obviously decreased when the expansion-chambered nozzles were used, and the spray pattern became narrower as the ratio of chamber diameter to discharge nozzle diameter increased. By contrast, the increase in ratio of two nozzle diameters enlarged the spray radius. Surface temperature and heat flux with different nozzles and cryogens showed a similarity, and correlations of surface temperature and heat flux were proposed. The introduction of expansion-chambered nozzles could effectively improve the spray cooling capacity. The minimum average surface temperature during the fully developed spray period could be reached for both R134a spray and R404A spray by an expansion-chambered nozzle with a chamber diameter to discharge nozzle diameter ratio of roughly 5.0 and an inlet nozzle diameter to discharge nozzle diameter ratio of roughly 0.6.