Atomistic Investigation on the Wetting Behavior and Interfacial Joining of Polymer-Metal Interface.

Mingyong Zhou,Bingyan Jiang,Liang Fu,Fengze Jiang,Dietmar Drummer

doi:10.3390/polym12081696

Mingyong Zhou, Bingyan Jiang + Show 3 more

Open Access

https://doi.org/10.3390/polym12081696

Copy DOI

Abstract

Polymer-metal hybrid structures can reduce the weight of components while ensuring the structural strength, which in turn save cost and subsequently fuel consumption. The interface strength of polymer-metal hybrid structure is mainly determined by the synergistic effects of interfacial interaction and mechanical interlocking. In this study, the wetting behavior of polypropylene (PP) melt on metal surface was studied by molecular dynamics simulation. Atomistic models with smooth surface and nano-column arrays on Al substrate were constructed. Influences of melt temperature, surface roughness and metal material on the wetting behavior and interfacial joining were analyzed. Afterwards the separation process of injection-molded PP-metal hybrid structure was simulated to analyze joining strength. Results show that the initially sphere-like PP model gradually collapses in the wetting simulation. With a higher temperature, it is easier for molecule chains to spread along the surface. For substrate with rough surface, high density is observed at the bottom or on the upper surface of the column. The contact state is transitioning from Wenzel state to Cassie–Baxter state with the decrease of void fraction. The inner force of injection-molded PP-Fe hybrid structure during the separation process is obviously higher, demonstrating a greater joining strength.

Highlights

Lightweight metallic materials, such as aluminum (Al), magnesium (Mg) and titanium (Ti) are widely used in the applications of automobile, aerospace and electronics because to their high specific stiffness, weight reduction and wear resistance
This paper aims to explore the wetting behavior of polymer melt on metal surface and to investigate the joining strength at the interface
The inner force-time curves indicate the inner behaviors during the separation process that is used in the previous reports to analyze the interfacial joining properties [36,37]

Summary

Introduction

Lightweight metallic materials, such as aluminum (Al), magnesium (Mg) and titanium (Ti) are widely used in the applications of automobile, aerospace and electronics because to their high specific stiffness, weight reduction and wear resistance. Due to the inherent characteristics in some cases, these materials have shortcomings in thermal conductivity, processing complexity and high cost of raw material. Polymer and plastic material are playing dominant roles in the modern industrial economy and the social life, mainly with the benefits of simple molding, low cost and light weight. Polymer and plastic products have the disadvantages of low mechanical strength, poor dimensional and thermal stability. By combing the advantages of metal and polymer materials, the polymer-metal hybrid structure can greatly reduce the weight of components while ensuring the structural strength, which in turn saves cost and subsequently fuel consumption [1,2,3,4,5,6].

Objectives

Methods

Conclusion