Abstract
This computational study investigates the adsorption of various spiropyran and merocyanine isomers on a NaCl substrate using a combination of density functional theory (DFT) and molecular mechanics (MM) calculations. Four different charge methods were used to determine the partial atomic charges for the adsorbate molecules, including Mulliken population analysis and three electrostatic potential (ESP) methods (Merz-Kollman, ChelpG, and Hu-Lu-Yang), while three different force fields (AMBER 3, CHARMM 27, and MM+) were employed for the MM calculations. The results show that the various DFT charge methods produced similar outcomes for the molecules' partial atomic charges, with some exceptions for individual atoms and methods. Additionally, it was found that the ESP charge methods were more sensitive to the conformer orientation than the Mulliken approach. The adsorption behavior of merocyanine conformers with the central bond in trans orientation (T-conformers) was similar for various configurations, with the molecule adsorbing mostly flat with its aromatic rings almost parallel to the substrate. However, C-conformers (with their central bond in cis orientation) and spiropyran isomers exhibited inconsistent adsorption behavior, mostly because only some of the aromatic rings contributed to the adsorption behavior. Due to additional van der Waals interactions of more aromatic rings, the adsorption energies for T-conformers are consistently 0.2-0.3 eV higher than for C-conformers and for spiropyran. The study found that the adsorption geometries and energies of stable T-conformers were independent of the partial atomic charge scheme and force field used, and C-conformers show parameter-dependent behavior upon adsorption, leading to metastable configurations. These findings indicate viable pathways during the spiropyran-merocyanine isomerization reactions. Therefore, the results provide initial insights into the possibility of switching spiropyran isomers into merocyanine isomers and vice versa after adsorption onto substrates.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.