Abstract

Three non-Newtonian constitutive models are employed to investigate how fluid rheological properties influence the development of laterally asymmetric flows past confined cylinders. First, simulations with the shear-thinning but inelastic Carreau–Yasuda model are compared against complementary flow velocimetry experiments on a semidilute xanthan gum solution, showing that shear-thinning alone is insufficient to cause flow asymmetry. Next, simulations with an elastic but non-shear-thinning finitely extensible non-linear elastic dumbbell model are compared with experiments on a constant viscosity solution of poly(ethylene oxide) (PEO) in an aqueous glycerol mixture. The simulations and the experiments reveal the development of an extended downstream wake due to elastic stresses generated at the stagnation point but show no significant lateral asymmetries of the flow around the sides of the cylinder. Finally, the elastic and shear-thinning linear Phan–Thien–Tanner (l-PTT) model is compared with experimental velocimetry on a rheologically similar solution of PEO in water. Here, at low flow rates, lateral symmetry is retained, while the growth of a downstream elastic wake is observed, in qualitative similarity to the non-shear-thinning elastic fluids. However, above a critical flow rate, the flow bifurcates to one of the two stable and steady laterally asymmetric states. Further parameter studies with the l-PTT model are performed by varying the degrees of shear-thinning and elasticity and also modifying the confinement of the cylinder. These tests confirm the importance of the coupling between shear-thinning and elasticity for the onset of asymmetric flows and also establish stability and bifurcation diagrams delineating the stable and unstable flow states.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.