Assessment of wood surface roughness: comparison of tactile roughness and three-dimensional parameters derived using a robust Gaussian regression filter

Abstract

Japanese oak and Japanese beech were sanded by hand with abrasive papers of varying grit number. Two three-dimensional parameters selected to characterize their surface roughness – one parameter for the distribution of roughness-profile peaks and the other for the relative area of the roughness-profile peaks above the threshold height – were compared against tactile roughness. The parameters were obtained from roughness profiles as determined by a robust Gaussian regression filter (RGRF) using seven cutoffs. The RGRF filtering process was adjusted specifically for the evaluation of wood surface roughness. Except for a cutoff wavelength of 0.25 mm, the RGRF lent itself well to the determination of roughness profiles. No distortion of roughness profiles occurred around deep valleys, and there was a good correlation between the parameters and tactile roughness.