Assessment of the viability of pozzolanic activity of copper slag for use as supplementary cementitious material in ordinary Portland cement

Abstract

The production of ferrous as well as non-ferrous metals generates slag as a byproduct material. Ferrous slags are extensively used in the construction sector as supplementary cementitious material (SCM) and aggregates. In this regard, the investigation of potential applications in similar areas for slags derived from the production of non-ferrous metals can help to address issues associated with their disposal, dumping, environmental concerns, etc. The primary aim of this research is to assess the pozzolanic activity of copper slag (CS), a type of non-ferrous slag. This investigation is conducted to replace a portion of ordinary Portland cement (OPC) incorporating CS as an SCM for sustainable construction. To assess the reactivity of the CS, comparisons were drawn with a known pozzolanic material fly ash (FA), and an inert material quartz powder (QP). The processing of raw CS (granular material) was carried out using a laboratory scale ball mill to achieve varying fineness to evaluate the effect of specific surface area (SSA) on reactivity. Initially, the investigations were conducted on paste samples of OPC-CS and suspensions of CS-calcium hydroxide (CH) and were later extended to mortar studies. Mechanical characteristics such as compressive strength and open porosity of mortar specimens were determined to correlate with the paste studies results. The findings suggest that CS does exhibit pozzolanic characteristics although its reactivity is comparatively lower than that of FA. An increase in the fineness of the CS resulted in enhanced pozzolanic activity. Analysis of the hydrated suspension samples showed the formation of Fe-siliceous hydrogarnet phase indicating “Fe” from CS was involved in the reaction with CH. Although OPC-CS mortar samples exhibited similar open porosity compared to OPC-QP mortar samples, the interfacial transition zone (ITZ) porosity in mortar samples of OPC-CS was observed to be reduced indicating the densification of the region due to the pozzolanic reaction of CS. The permissible replacement of OPC with CS as a substitute for FA can be adjusted according to the material's fineness and the desired compressive strength.