Abstract
The performance of a recently introduced spectral computed tomography system based on a dual‐layer detector has been investigated. A semi‐anthropomorphic abdomen phantom for CT performance evaluation was imaged on the dual‐layer spectral CT at different radiation exposure levels (CTDI vol of 10 mGy, 20 mGy and 30 mGy). The phantom was equipped with specific low‐contrast and tissue‐equivalent inserts including water‐, adipose‐, muscle‐, liver‐, bone‐like materials and a variation in iodine concentrations. Additionally, the phantom size was varied using different extension rings to simulate different patient sizes. Contrast‐to‐noise (CNR) ratio over the range of available virtual mono‐energetic images (VMI) and the quantitative accuracy of VMI Hounsfield Units (HU), effective‐Z maps and iodine concentrations have been evaluated. Central and peripheral locations in the field‐of‐view have been examined. For all evaluated imaging tasks the results are within the calculated theoretical range of the tissue‐equivalent inserts. Especially at low energies, the CNR in VMIs could be boosted by up to 330% with respect to conventional images using iDose/spectral reconstructions at level 0. The mean bias found in effective‐Z maps and iodine concentrations averaged over all exposure levels and phantom sizes was 1.9% (eff. Z) and 3.4% (iodine). Only small variations were observed with increasing phantom size (+3%) while the bias was nearly independent of the exposure level (±0.2%). Therefore, dual‐layer detector based CT offers high quantitative accuracy of spectral images over the complete field‐of‐view without any compromise in radiation dose or diagnostic image quality.
Highlights
Computed tomography (CT) is widely used in diagnostic imaging.Many of today’s design considerations in state-of-the-art CT systems provide a reduction in radiation exposure and enhance contrast-todose efficiency while increasing the perceived contrast-to-noiseratio
A newly introduced dual-layer spectral CT scanner has been characterized in terms of its spectral imaging performance
The largest factor contributing to this result is the reduced noise level in virtual mono-energetic images (VMI) compared to conventional images which was shown to be largely independent of the energy
Summary
Many of today’s design considerations in state-of-the-art CT systems provide a reduction in radiation exposure and enhance contrast-todose efficiency while increasing the perceived contrast-to-noiseratio. Among these developments, advanced iterative reconstruction techniques are a very promising tool.[1,2,3,4] despite these advances, extracting accurate information from CT images like object size and composition is still a challenge. Spectral imaging methods using different dual-energy approaches (kVp switching,[5] dual x-ray sources6) have attracted increased attention in research and clinical practice. A parametrization that is commonly used in diagnostic imaging expresses the total linear attenuation as the sum of photoelectric absorption and Compton effect[9]
Sign-in/Register to view highlights & summary Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
