Abstract
AbstractIn this study, comprehensive modeling and simulations were developed and carried out to perform the investigation of the thermal performance of the enclosed thermosiphon through pool boiling in the evaporator sector and the condensation of the liquid film in the condenser part. To simulate these phenomena, the volume of fluid model was utilized. The simulation modeling using the computational fluid dynamics (CFD) technique was validated with existing experimental results, and a good agreement was reached. The simulation results were presented and evaluated in terms of temperature profiles and contours, the volume of fraction contours, and velocity vector distribution. Moreover, the thermal performance (ie, the heat transfer coefficient and thermal resistance) through the thermosiphon operation was analyzed. From the simulation results, it is found that the thermosiphon performance can be improved by the tilt angle and fill ratio. The results indicated that the optimal performance (ie, a high heat transfer coefficient and a low thermal resistance) was attained at a power input of 250 W, tilt angle of 90°, and fill ratio of 0.5. The established CFD simulations effectively predicted the formation of two‐phase flow pattern and boiling and condensation zones with water at a low power input, termed as geyser boiling.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.