Assessment of dynamic characteristics of fluidized beds via numerical simulations

Abstract

Euler–Lagrange simulations coupled with the multiphase particle-in-cell (MP-PIC) approach for considering inter-particulate collisions have been performed to simulate a non-reacting fluidized bed at laboratory-scale. The objective of this work is to assess dynamic properties of the fluidized bed in terms of the specific kinetic energy of the bed material kS in J/kg and the bubble frequency fB in Hz, which represent suitable measures for the efficiency of the multiphase momentum exchange and the characteristic timescale of the fluidized bed system. The simulations have reproduced the bubbling fluidization regime observed in the experiments, and the calculated pressure drop Δp in Pa has shown a reasonably good agreement with measured data. While varying the bed inventory mS in kg and the superficial gas velocity uG in m/s, kS increases with uG due to the increased momentum of the gas flow, which leads to a reinforced gas-to-solid momentum transfer. In contrast, fB decreases with mS, which is attributed to the increased bed height hB in m at larger mS. An increased gas temperature TG from 20 to 500 °C has led to an increase in kS by approximately 50%, whereas Δp, hB, and fB are not sensitive to TG. This is due to the increased gas viscosity with TG, which results in an increased drag force exerted by the gas on the solid phase. While up-scaling the reactor to increase the bed inventory, bubble formation is enhanced significantly. This has led to an increased fB, whereas kS, hB, and Δp remain almost unchanged during the scale-up process. The results reveal that the general parameters such as hB and Δp are not sufficient for assessing the hydrodynamic behavior of a fluidized bed while varying the operating temperatures and up-scaling the reactor dimension. In these cases, the dynamic properties kS and fB can be used as more suitable parameters for characterizing the hydrodynamics of fluidized beds.