Assessment of direct evaporative cooler performance with a cooling pad made from banana midrib and ramie fiber

Abstract

PurposeThe paper aims to apply Buckingham Pi dimensional analysis method for assessing direct evaporative cooler performance with a cooling pad made of banana midrib and ramie fiber. The saturation efficiency acted as the indicator performance of the evaporative cooler.Design/methodology/approachThe paper describes an experimental study of the direct evaporative cooler with a cooling pad made of banana midrib and rami fiber. There were six parameters in the experiment: absorbed water as a dependent variable was affected by independent parameters such as air velocity and temperature, cooling pad cross-section area and thickness. Based on these variables, we arranged three dimensionless numbers and their correlation.FindingsThe paper provides three calculated dimensionless numbers plotted on a curve with a specific correlation. The curve trends for 30 mm and 50 mm pad thickness were almost similar. The range of Reynolds number for 10 mm pad was narrower than other pad thicknesses. The thicker the cooling pad, the more extensive was the calculated Reynolds number range. A new curve exhibited the relationship between the evaporation rate with the μA/t number. The broader cooling pad cross-section, the thinner pad thickness, and the lower pad temperature were factors that increased the evaporation rate, even though the increase was less significant.Originality/valueA new material in cooling pad from banana midrib fiber was tested and compared to ramie fiber and conventional cooling pad.