Abstract
Adhesive bonds, including car putty coatings, are used in the construction of modern motor vehicles. Therefore, it is important to improve methods that allow nondestructive evaluation of the properties of these joints. The main objective of this study was to evaluate selected properties of putty coatings such as the width of the applied coating and adhesion to the substrate based on changes in ultrasonic wave parameters. The research was carried out in two stages. In the first, the values of the surface wave amplitude were determined as a function of the width of the coating to the substrate. It was found that as the width of the coating increases, the amplitude of the surface wave pulse decreases. The second stage involved correlation studies to relate the reflection coefficient |r| to the adhesion of the coating to the substrate. Based on the results, it was found that as the value of the reflection coefficient decreases, the value of the coating’s adhesion to the substrate increases. The determined values of this parameter range from 0.30 to 0.86, which correspond to the adhesion of the range 1.51 to 18.97 MPa. The obtained test results have practical significance and can be used in evaluating the condition of coatings in vehicle body repair shops.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
