Abstract
Abstract The use of composite metal stacks has been increasing and in this work, armour steel, sandwiched between two GFRP panels, is drilled with Tungsten Nitride coated drills and the roundness error in the top panel and the bottom panel are measured with the help of CMM. The effects of the input parameters on the roundness error are analyzed separately for the top and bottom panels. The values of roundness error are very less for the bottom GFRP panel and this is because of less vibration experienced by the drill due to the guided action of the middle metal panel.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
