Abstract
Biofilters have been shown to be efficient for removing pollutants from different water effluents, but little information is available about their capacity to remove highly polar pesticides from agricultural run-off waters. In this study, we assess the capacity of three different biofilter-supporting materials (sand, peat soil, and pine bark) to remove five phenoxyacid herbicides (mecoprop, dicamba, MCPA, dichlorprop and 2,4-D) and five non-ionic pesticides (atrazine, simazine, fenitrotion, diazinon, and alachlor) from real agricultural run-off waters. The experimental design included three columns 120cm in length and 15cm in diameter, each filled with 100cm of one of the selected supporting materials. After 30days of acclimation, the columns were fed with agricultural run-off water spiked at 10μgL-1 with each of the studied pesticides for 20days at a hydraulic loading rate (HLR) of 0.32mday-1. The results show that the sand filter was the best supporting material for removing phenoxyacid herbicides (77% on average), whereas peat soil and pine bark were best for removing non-ionic pesticides (72% on average). The attenuation of mecoprop and dichlorprop correlated negatively with the enantiomeric fraction. Therefore, this study shows that the use of waste-to-product materials in biofilter systems is a good solution for removing pollutants from agricultural run-off waters.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Environmental science and pollution research international
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.