Abstract

BackgroundDue to the advent of SNP array technology, a genome-wide analysis of genetic differences between populations and breeds has become possible at a previously unattainable level. The Wright’s fixation index (Fst) and the principal component analysis (PCA) are widely used methods in animal genetics studies. In paper we compared the power of these methods, their complementing each other and which of them is the most powerful.ResultsComparative analysis of the power Principal Components Analysis (PCA) and Fst were carried out to reveal genetic differences between herds of Holsteinized cows. Totally, 803 BovineSNP50 genotypes of cows from 13 herds were used in current study. Obtained Fst values were in the range of 0.002–0.012 (mean 0.0049) while for rare SNPs with MAF 0.0001–0.005 they were even smaller in the range of 0.001–0.01 (mean 0.0027). Genetic relatedness of the cows in the herds was the cause of such small Fst values. The contribution of rare alleles with MAF 0.0001–0.01 to the Fst values was much less than common alleles and this effect depends on linkage disequilibrium (LD). Despite of substantial change in the MAF spectrum and the number of SNPs we observed small effect size of LD - based pruning on Fst data. PCA analysis confirmed the mutual admixture and small genetic difference between herds. Moreover, PCA analysis of the herds based on the visualization the results of a single eigenvector cannot be used to significantly differentiate herds. Only summed eigenvectors should be used to realize full power of PCA to differentiate small between herds genetic difference. Finally, we presented evidences that the significance of Fst data far exceeds the significance of PCA data when these methods are used to reveal genetic differences between herds.ConclusionsLD - based pruning had a small effect on findings of Fst and PCA analyzes. Therefore, for weakly structured populations the LD - based pruning is not effective. In addition, our results show that the significance of genetic differences between herds obtained by Fst analysis exceeds the values of PCA. Proposed, to differentiate herds or low structured populations we recommend primarily using the Fst approach and only then PCA.

Highlights

  • Due to the advent of SNP array technology, a genome-wide analysis of genetic differences between populations and breeds has become possible at a previously unattainable level

  • It can be suggested that in average SNPs with MAF 0.1–0.4 distributed in genome closer to each other than remaining SNPs leading to the largest linkage disequilibrium (LD) between them

  • Assessing the impact of outliers removal on Wright’s fixation index (Fst) data On the first step we evaluated the impact of the outliers on Fst values

Read more

Summary

Introduction

Due to the advent of SNP array technology, a genome-wide analysis of genetic differences between populations and breeds has become possible at a previously unattainable level. The Wright’s fixation index (Fst) and the principal component analysis (PCA) are widely used methods in animal genetics studies. Farmed animals should have large genetic variation in exterior, production and fitness traits. Genetic variation is the basis for survival and maintaining of cattle populations. On genome level variation appears as considerable allelic diversity and heterozygosity. Genomic data help to track herds’ genetic divergence at molecular level. Knowledge of genetic diversity is important for small breed conservation and crossbreeding strategies [1, 2]. Contemporary technologies allow to use massive SNPs data for these goals

Methods
Results
Discussion
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call