Abstract
The effect of electrode positive time cycle (% EP) of the alternating current TIG process has been investigated for aluminium wire+arc additive manufacture of linear walls. The study considered the effect on oxide removal, linear wall dimensions, microstructure, mechanical properties as well as the effect on electrode wear. The results showed that the effective wall width was minimum at 20%EP with a corresponding maximum in layer height. It was also observed that increasing the% EP increased the electrode wear rate, which in turn affected the arc stability. Microstructure analysis showed a noticeable increase in the grain size for higher% EP. The study also showed that% EP had no significant effect on mechanical properties. From a heat input analysis, a direct correlation was observed between the arc voltage and the% EP. The study also indicated that there could be other contributing factors to wall dimensions. For aluminium wire+arc additive manufacture of linear walls, minimum cleaning ranged between 10%EP and 20%EP.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
