Assessing Quadriceps Muscle Contraction Using a Novel Surface Mechanomyography Sensor during Two Neuromuscular Control Screening Tasks.

Abstract

Electromyography (EMG) is the clinical standard for capturing muscle activation data to gain insight into neuromuscular control, yet challenges surrounding data analysis limit its use during dynamic tasks. Surface mechanomyography (sMMG) sensors are novel wearable devices that measure the physical output of muscle excursion during contraction, which may offer potential easy application to assess neuromuscular control. This study aimed to investigate sMMG detection of the timing patterns of muscle contraction compared to EMG. Fifteen healthy participants (mean age = 31.7 ± 9.1 y; eight males and seven females) were donned with EMG and sMMG sensors on their right quadriceps for simultaneous data capture during bilateral deep squats, and a subset performed three sets of repeated unilateral partial squats. No significant difference in the total duration of contraction was detected by EMG and sMMG during bilateral (p = 0.822) and partial (p = 0.246) squats. sMMG and EMG timing did not differ significantly for eccentric (p = 0.414) and concentric (p = 0.462) phases of muscle contraction during bilateral squats. The sMMG magnitude of quadriceps excursion demonstrated excellent intra-session retest reliability for bilateral (ICC3,1 = 0.962 mm) and partial (ICC3,1 = 0.936 mm, n = 10) squats. The sMMG sensors accurately and consistently provided key quadriceps muscle performance metrics during two physical activities commonly used to assess neuromuscular control for injury prevention, rehabilitation, and exercise training.