Assessing Low-Constraint Fracture Toughness Test Methods Using Clamped SENT Specimens

Abstract

Abstract The low-constraint fracture toughness can be measured using a single edge-notched tension (SENT) specimen in the clamped-end conditions. The SENT specimen has been used in the oil and gas industry in the strain-based design and the crack assessment for transmission pipelines. Since 2006 when DNV published the first SENT test practice, many investigations have been done, and various SENT test methods were developed, including CANMET and ExxonMobil methods in terms of the J-integral and CTOD. The effort led to the first SENT test standard BS 8571 being published in 2014. However, the experimental evaluation methods remain in developing, and different methods may determine inconsistent results. For this reason, the present paper gives a brief review on SENT fracture testing and assesses the available test methods, including progresses on study of stress intensity factor, geometric eta factors, elastic compliance equation, and constraint m factor as well. The difference between J-converted CTOD and double clip gage measured CTOD is also discussed. On those bases, agreements and challenges in SENT testing are identified. The results provide a direction for further investigation to improve the current SENT test methods.