Abstract
This paper describes some effects of cutting on power loss, localised flux distribution and B– H curves of a fully processed, high permeability non-oriented electrical steel. Cutting a single sheet into narrow strips increased the power loss by up to 30% and significantly changed the B– H characteristics. The change in flux distribution caused by cutting was lower when magnetised at 400 Hz than at 50 Hz.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
