Abstract
The as-cast microstructure, mechanical properties and casting fluidity of ZA84 alloy containing TiC were investigated. The experimental results indicate that adding 0.5wt%TiC to ZA84 alloy can refine the as-cast microstructure, and do not cause the formation of any new phase. After 0.5wt%TiC was added to the ZA84 alloy, the morphology of ternary phases on the grain boundaries changed from coarse quasi-continuous net to fine disconnected net, and the distribution of ternary phases became dispersive and homogeneous. At the same time, the tensile properties of ZA84+0.5TiC alloy at room temperature were comparable to those of AZ91D alloy, and were higher than those of ZA84 alloy. At 150 °C, the tensile and creep properties of ZA84+0.5TiC alloy were also higher than those of ZA84 and AZ91D alloys. In addition, compared with the AZ91D alloy, the casting fluidity of ZA84+0.5TiC alloy was slightly poor, but better than that of ZA84 alloy. The reason could be related to the effect of TiC on the solidification temperature range of ZA84 alloy.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Journal of Wuhan University of Technology-Mater. Sci. Ed.
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
