Abstract
The effect of ageing processes on internal bond strength of three-part specimens produced from Norway spruce wood (Picea abies Karst.) bonded with one-component polyurethane (PUR), two-component emulsion polymer isocyanate (EPI), melamine-urea-formaldehyde (MUF) or phenol-resorcinol-formaldehyde (PRF) adhesive was studied. By varying the grain angle of the middle part from 0° (parallel to grain of the surface layers) to 90° (perpendicular to grain of the surface layers) in incremental steps of 10° the effect of grain direction was investigated. The specimens were exposed to a three-step ageing cycle lasting for seven days (50°C/95% relative humidity (rH), −20°C/65–70% rH and 75°C/15% rH) which was repeated twelve and twenty-four times, respectively. In general, a decrease in internal bond strength of the exposed specimens was observed. For all tested adhesive systems, influence of ageing processes was more pronounced for flat-to-end grain joints compared to longitudinal joints. For samples bonded with PUR adhesive strength reduction was lower compared to the other adhesives used.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
