Arsenic speciation in aqueous samples using a selective As(III)/As(V) preconcentration in combination with an automatable cryotrapping hydride generation procedure for monomethylarsonic acid and dimethylarsinic acid

Abstract

Differentiation between As(III) and As(V) is accomplished using earlier developed selective preconcentration methods (carbamate and molybdate mediated (co)precipitation of As(III) and As(V) respectively) follewed by AAS detection of the (co)precipitates. Apart from this, separation of methylated arsenic species is performed by an automatable system comprising a continuous flow hydride generation unit in which monomethylarsonic acid (MMAA) and dimethylarsinic acid (DMAA) are converted into their corresponding volatile methylarsines, monomethylarsine (MMA) and dimethylarsine (DMA) respectively. These species are cryogenically trapped in a Teflon-line stainless stell U-tube packed with a gas chromatographic solid-phase and subsequently separated by selective volatilization. A novel gas drying technique by means of a “Perma Pure” dryer was applied successfully prior to trapping. Detection is by atomic absorption spectrometry (AAS). MMAA and DMAA are determined with absolute limits of detection of 0.2 and 0.5 ng, respectively. Investigation of the behaviour of the methylarsines in the system was conducted with synthesized73As labeled methylated arsenic species. It was found that MMA is taken through the system quantitatively whereas DMA is recovered for about 85%. The opumized system combined with selective As(III)/As(V) preconcentration has been tested out for arsenic speciation of sediment interstitial water from the “Chemiehaven” at Rotterdam. The obtained concentrations are 28.5, 26.8 and 0.60 ng·ml−1 for As(III), As(V) and MMAA, respectively, whereas the DMAA concentration was below 0.16 ng·ml−1.