Argon and Nd:YAG Lasers for Caries Prevention in Enamel

Abstract

The aim of this study was to investigate the effect of Nd:YAG and argon laser irradiations on enamel demineralization after two different models to induce artificial caries. It is believed that the use of the high-intensity laser on the dental structure can lead to a more acid-resistant surface. Twenty-one extracted human third molars were sectioned into tooth quarters. The quarters were distributed in three groups: Group I (control), untreated; Group II, Nd:YAG laser (60 mJ, 15 pps, 47.77 J/cm(2), 30 sec); and Group III, argon laser (250 mW, 12 J/cm(2), 48 sec). Tooth quarters from each group were subjected to two different demineralization models: cycle 1, a 14 day demineralization (pH 4.5; 6 h) and remineralization (pH 7.0; 18 h) solutions, 37 °C and cycle 2, 48 h in demineralization solution (pH 4.5). Samples were prepared in slices (60-100 μm thick) to be evaluated under polarized light microscopy. Demineralization areas were measured (mm(2)) (n=11). Data were analyzed by ANOVA and Tukey's test (p<0.05). Means followed by different letters are significantly different: 0.25 A (control, cycle 48 h); 0.18 AB (control, cycle 14 days); 0.17 AB (Nd:YAG, cycle 14 days); 0.14 BC (argon, cycle 48 h); 0.09 BC (Nd:YAG, cycle 48 h), and 0.06 C (argon, cycle 14 days). The argon laser was more effective for caries preventive treatment than Nd:YAG laser, showing a smaller demineralization area in enamel.