Archimedes Screws for Microhydro Power Generation

Abstract

Archimedes screw generators (ASGs) are beginning to be widely adopted at low head hydro sites in Europe, due to high efficiency (greater than 80% in some installations), competitive costs and low environmental impact. Compared to other microhydro generation technologies, ASGs have greatest potential at low head sites (less than about 5 m). The performance of an Archimedes screw used as a generator depends on parameters including screw inner and outer diameter, slope, screw pitch and number of flights, and inlet and outlet conditions, as well as site head and flow. Despite the long history of the Archimedes screw, there is very little on the dynamics of these devices when used for power generation in the English literature. Laboratory tests of small Archimedes screws (approximately 1 W mechanical power) have been conducted to support the design and validation of ASG design tools. This paper reports experimental results examining the relationship between torque, rotation speed and power. The laboratory screw maintained reasonable efficiency over wide ranges of operating conditions, although distinct efficiency peaks were found to occur. The cause of changes in power output caused by varying the water level at the outlet of the screw were attributed primarily to the corresponding variation in head, and dynamic limiting of screw rotation speed causing corresponding limits in volume flow through the screw. Test results were qualitatively consistent with data from a prototype ASG installed by Greenbug Energy in southern Ontario, Canada, and recent data reported from European laboratory tests and commercial installations.