Abstract
ABSTRACT The purpose of the method of AC/DC mixed gas tungsten arc welding (GTAW) is to improve the welding efficiency of aluminum alloy AC-GTAW. It is expected to make a great change in the aluminum alloy manufacturing industries. The feature of AC/DC mixed GTAW includes two parts, AC mode and DC mode, during the welding process. A comparison study between the AC/DC mixed GTAW and AC-GTAW is carried out by analyzing the arc characteristics and weld formation. The results showed that the uniformly distributed AC and DC signals were obtained in the AC/DC mixed GTAW. The front width and back reinforcement of the weld bead in the AC GTAW and the AC/DC mixed GTAW increased first and then decreased with increasing frequency. The geometrical parameters of the weld cross-section in the AC/DC mixed GTAW was increased, when the same frequency was used. For example, the frequency of 30 Hz was employed, the front width of the weld bead in the AC/DC mixed GTAW was increased to 0.3 mm compared with that of the AC-GTAW. The AC/DC mixed GTAW has a greater effective heat input compared with the AC GTAW due to introduction of the DC mode.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.