Abstract
Ink-jet printing (IJP) is a rapid prototyping method which is very promising for the manufacturing of multilayer hybrid circuits. Before the formulation of inks, the first step aims to ensure the stability of dielectric powder suspensions with the specifications required for the IJP process in terms of solid content, particle size, rheology, and stability versus sedimentation. A commercial glass silicate powder currently used as a dielectric material was studied during an attrition milling (i) for low ceramic loading (3vol.%) and (ii) for significant ceramic loading (20vol.%) with different dispersants: polyelectrolytes with carboxylate groups, and sulfate groups. The milling step impact on the surface chemistry of the powder was investigated in both cases. A potassium polycarboxylate was found to be the most efficient dispersant, and the optimization of the dispersant rate was carried out through zeta potential measurements, viscosity, dispersant adsorbed rate, and sedimentation tests. An attempt of correlation between some of these properties is proposed. The preliminary ejection tests obtained with an ink prepared from an optimized suspension allowed to generate a wide range of drop velocity (0.7 to 4.2m/s) and drop diameter (47 to 56μm), which will be useful in a further step to optimize the characteristics of green ink-jet printed dielectric layers.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.