Approaching 3D printing in oral and maxillofacial surgery - suggestions for structured clinical standards.

Abstract

With respect to the European Union 2017 amendment of the Medical Device Regulations (MDR), this overview article presents recommendations concerning medical 3D printing in oral and maxillofacial surgery (OMFS). The MDR were screened for applicability of the rules to medical in-house 3D printing. Applicable regulations were summarized and compared to the status of medical use of 3D printing in OMFS in Germany. Recommendations were made for MDR concerning medical 3D printing. In-house printed models, surgical guides, and implants fall under the category of Class I-III, depending on their invasive and active properties. In-house medical 3D printing for custom-made medical devices is possible under certain prerogatives: (1) the product is not being used in another facility, (2) appropriate quality systems are applied, (3) the reason for omitting commercial products is documented, (4) information about its use is supplied to the responsible authority, (5) there is a publicly accessible declaration of origin, identification, and conformity to the MDR, (6) there are records of manufacturing site, process and performance data, (7) all products are produced according to the requirements proclaimed before, and (8) there is an evaluation of clinical use and correction of possible issues. Several aspects must be addressed for in house medical 3D printing, according to the MDR. Devising MDR related to medical 3D printing is a growing challenge. The implementation of recommendations in OMFS could help practitioners to overcome the challenges and become aware of the in-house production and application of 3D printed devices.