Applying Rate Transient Analysis (RTA) to integrate geological and engineering data

Abstract

The Blasingame typecurve in Fekete’s Rate Transient Analysis (RTA) software has been used at Santos to increase the understanding and integration of well and reservoir data; however, the authors have discovered that in some cases the tool produced anomalous results, such as permeability being too low. The potential consequence of this was incorrectly writing off reserves or making projects (in particular compression projects) fail economic tests. After testing various hypotheses, a simple yet unorthodox solution was only discovered in a field where the anomaly was more profound, and required integrating geology and geophysics to explain it. This solution has since been applied in RTA models across numerous other fields, and it has improved the quality and confidence of these models. The solution was the realisation that in many cases the accessed gas in place (GIP) increased over time, but the underlying model in RTA assumes a single tank, linear P/z. Matching the RTA model with the initial reservoir pressure and final accessed GIP results in over-predicting the reservoir pressures, resulting in an artificially low permeability. The authors discovered that the appropriate well and reservoir parameters could be obtained by matching the late time data using a lower initial reservoir pressure value corresponding to when the well had accessed the final GIP volume but not the initial reservoir pressure. This step was initially regarded to be counter-intuitive as the initial pressure is a measured property. Numerous reviews have endorsed this methodology, which is now being used as a standard at Santos.