Applications of BOP reagent in solid phase synthesis. Advantages of BOP reagent for difficult couplings exemplified by a synthesis of [Ala 15]-GRF(1-29)-NH2.

Abstract

The BOP reagent [benzotriazol-l-yl-oxy-tris-(dimethylamino)phosphonium hexa-fluorophosphate] introduced by Castro et al. [Tetrahedron Lett. (1975) 14, 1219-1222] is ideally suited for solid phase peptide synthesis. The rate of coupling using BOP compared favorably to DCC and other methods of activation including the symmetrical anhydride and DCC/HOBt procedures. BOP couplings using the solid phase procedure proceeded more rapidly and to a greater degree of completion for peptide bond formations that were previously determined to be very slow using the conventional DCC method. Stepwise solid phase peptide synthesis using BOP was successfully utilized for the preparation of the (22-29) and (13-29) fragments of [Ala15]-GRF(1-29)-NH2. Single couplings with 3 equiv. BOP and Boc-amino acids and 5.3 equiv. of diisopropylethylamine in DMF were used for each cycle. The yields of the fragments were superior and the purities comparable using the BOP procedure (single couplings) to those observed using multiple couplings via the DCC coupling method. A total synthesis of [Ala15]-GRF(1-29)-NH2 was also carried out using the BOP procedure (single couplings and 3 equiv. BOP and Boc-amino acids and 5.3 equiv. diisopropylethylamine in DMF for each cycle). Multiple couplings were only required for Boc-Asn-OH due to the proposed formation of Boc-aminosuccinimide during activation. The resultant GRF(1-29) analog was comparable to a control prepared with multiple DCC couplings under optimized conditions. In a parallel study, unprotected Boc-(hydroxy)-amino acids were successfully coupled with the BOP reagent. However, the number of coupling cycles after the introduction of unprotected hydroxy-amino acid must be minimal (less than 10). The use of the BOP reagent with unprotected Tyr in solid phase peptide synthesis was also clearly established.