Application of Two Novel Enhanced Oil Recovery Processes in the Bakken Shale

Abstract

Abstract Oil production via horizontal wells with multistage fracture stimulation treatment completions in the Bakken shale of North Dakota and Montana began in 2003. Since then, over 19,000 Bakken shale horizontal wells have been completed and placed into production. Oil production from horizontal Bakken shale oil wells peaked in November 2019 at 1.5 million barrels/day, and is at about 1.2 million barrels/day as of September, 2022 (EIA). There have been several shale oil EOR tests conducted over the last several years, involving the injection of water, CO2 and natural gas. This paper builds upon shale EOR modeling work described in a 2019 NETL report. In that report, a compositional simulation model of the Bakken was constructed, and a production history match on primary oil, gas and water production from a group of wells was obtained. The match model was then used to evaluate the enhanced oil recovery via cyclic injection of CO2, dry gas, and wet gas. This paper utilizes some data from that report to assess two novel, proprietary shale oil EOR processes in the Bakken, in the same area of the Williston Basin. The paper illustrates how these proprietary shale oil EOR processes may be implemented at lower BHP to mitigate interwell communication, while enabling greater oil recovery than via injection of water, CO2 or natural gas. Compositional reservoir simulation modeling of the two novel EOR processes in the modeled Bakken shale wells indicates potential incremental oil recoveries of 200% and 300% of primary EUR may be achieved. The two novel shale oil EOR methods utilize a triplex pump to inject a liquid solvent having a specific composition into the shale oil reservoir, and a method to recover the injectant at the surface, for storage and reinjection. One of the processes enables further enhanced oil recovery via cyclic fracture stimulation at the start of the EOR process. The processes are fully integrated with compositional reservoir simulation to optimize the recovery of residual oil during each injection and production cycle. The patent pending shale oil EOR processes have numerous advantages over cyclic gas injection - shorter injection time, longer production time, smaller, lower cost injection volumes, no gas containment issue - much lower risk of interwell communication, elimination of the need to buy and sell injectant during each cycle, much better economics, scalability, faster implementation, optimization via integration with compositional reservoir simulation modeling, and lower emissions. If implemented early in the well life, their application may preclude the need for artificial lift, to produce more oil sooner, resulting in a shallower decline rate and higher reserves.