Abstract

Preliminary investigations have been conducted to discuss the possibility of measuring the thermal conductivity of hydrogen gas by the three-omega method. A one-dimensional analytical solution for the 3ω component is derived which includes the effect of the wire heat capacity. It is shown that it is very important to take into account the wire heat capacity in the calculation to measure the thermal conductivity of gas by the three-omega method. In contrast, the wire heat capacity is less important for the thermal conductivity of the liquid or solid phase. The importance of the wire heat capacity is found to increase with increasing frequency and decrease if the sample thermal conductivity is high. In order to measure the thermal conductivity of hydrogen gas at atmospheric pressure, a wire of diameter less than 1μm is necessary if the properties of the wire are to be neglected.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.