Application of the Taguchi method to areal roughness-based surface topography control by waterjet treatments

Abstract

Pure waterjet surface treatment without abrasive particles has a promising application in the biomedical field, because it induces compressive residual stresses on a metal surface and never leaves the tiny hard particles. In this work, the influence of operation pressure, standoff distance and the number of paths of the waterjet on the surface topography as well as the hardness was studied using the Taguchi method. The results showed that the most essential parameter is the operation pressure. By tuning the operation pressure from 100 to 300 MPa, the surface of Ti6Al4V specimens can be smoothed, roughened or damaged; when the surface layer is eroded, the new-born surface exhibits a clear stochastic nature accompanied by microvoids. The standoff distance benefits finer controlling the height parameters, whilst the number of paths affects the waviness. The hardening effect generated by the waterjet impingement extends to a few hundred-micron depth of the specimens, and the peak value of microhardness was found at a depth of 70 μm, which is an increase by greater than 20 %. The roughness parameters of Arithmetical mean height (Sa), Skewness (Ssk), Auto-correlation length (Sal), and Developed interfacial area ratio (Sdr) as a set are recommended to characterize the biomaterial's surface. The present research results promote the application of waterjet treatment in the field of fine-tuning biomaterial surface morphology.