Application of the Scanning Kelvin Probe for the study of the corrosion resistance of interfacial thin organosilane films at adhesive/metal interfaces

Abstract

The Scanning Kelvin Probe is introduced as a real time non-destructive in situ technique for the detection of de-adhesion at adhesive/metal oxide interfaces. Iron substrates and an epoxy adhesive served as model systems. Iron surfaces were coated with ultra-thin organosilane plasma polymer films from a microwave discharge and 3-(trimethoxysilyl)-propylamine films from dilute water based solutions. Surface and film characterisation was done by means of atomic force microscopy (AFM), X-ray photoelectron spectroscopy (XPS) and infrared reflection absorption spectroscopy (IRRAS). The effect of these interfacial films on the stability of the adhesive/metal joint was studied in corrosive environments. The Scanning Kelvin Probe allows the measurement of electrode potentials at buried polymer/metal interfaces with a spatial resolution of about 100 μm. The electrode potential characterises the reactivity of the interface. Moreover, by the variation of the oxygen partial pressure in the measurement chamber, local anodes and cathodes underneath the polymer can be distinguished. The kinetics of electrochemical de-adhesion can be effectively slowed down by thin 3-(trimethoxysilyl)-propylamine films at the interface. The effect of the adhesion promoter can be further improved when a thin SiO x layer, which inhibits electron transfer reactions, and is deposited on the iron surface prior to coating with the adhesion promoter.