APPLICATION OF THE MULTIFREQUENCY HORIZONTAL‐LOOP EM METHOD IN OVERBURDEN INVESTIGATIONS1

Abstract

AbstractIn recent years, geophysical methods (shallow seismic, electromagnetic, resistivity, ground penetrating radar) have been increasingly applied to overburden investigations. Their effectiveness has been found to depend significantly on local geological conditions. Compared with advanced seismic techniques, EM methods are faster and hence more cost‐effective, but they have not been considered sufficiently accurate.Analysis is carried out of data obtained with the multifrequency horizontal‐loop method (HLEM) in northeastern Ontario, where the overburden consists of Quaternary glacial and glaciolacustrine sediments. Surveying along 1‐6 km long profiles permitted recognition of bedrock inhomogeneities and selection of sites suitable for HLEM data interpretation using the layered model. Phasor diagrams and computer inversion based on the ridge regression technique were used to interpret HLEM soundings obtained at eight frequencies. Interpreted layer resistivities and thicknesses were correlated with the results of Rotasonic drilling at 70 sites. Relatively accurate estimates of overburden thickness (within 10%) could be obtained in about 80% of the cases. Nine examples of HLEM soundings are given and discussed: three each of one‐, two‐ and three‐layer situations. An appropriate interpretation model cannot be selected simply by minimizing the rms error or by analysing the parameter resolution matrix. Frequently, the most effective way of evaluating a solution is to consider whether resistivity values determined by inversion fit any of the ranges determined by statistical analyses of sediment resistivities. A previously published study of electrical properties of Quaternary sediments indicated that resistivities of clay, till and sand are stable within a fairly large area, such as the one under investigation. While the application of HLEM methods to mapping of Quaternary sediments can be considered a success, interpretation of EM data in regions covered by glacial sediments is more difficult than in weathered terrains, where near‐surface layering is more predictable. The problem of equivalence causes non‐uniqueness in interpretation. Thickness equivalence, which results in poor resistivity estimates, was found to affect areas convered by sand and till. Conductance equivalence caused poor resolution of thickness and resistivity for thin clay layers (less than 10 m).