Abstract
AbstractEssential Work of Fracture (EWF) tests have been carried out on double edge notched samples machined from injection molded sheets of commercial grades of polyoxymethylene homopolymer with different molecular weight averages. Most of the measurements were made at 1000C and over a range of test speeds in which polyoxymethylene is anticipated to undergo a macroscopic ductile‐brittle transition with decreasing strain rate. The results reflect both the existence and the molecular weight dependence of this transition, and are argued to be valid in terms of the European Structural Integrity Society's EWF draft test protocol under certain test conditions. However, it is shown that the applicability of the test method used here becomes highly questionable for test speeds in the immediate vicinity of the transition, owing to the influence of the initial ligament length on the crack tip deformation mechanisms.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
