Abstract
Inconel X-750, a nickel-chromium alloy, is found as a component in applications of the airframe and hot-air duct system. This paper presents the effect of different nanofluids (NF) concentration along with cutting speed and federate on Fz: cutting force, Ra: surface roughness and Vba: tool wear with the application of vegetable oil NF on turning of Alloy 750. The NF and vegetable oil taken for present investigation are nAl2O3 and coconut oil. Experimental is carried out using L9 orthogonal array and turned with PVD (AlTiN) coated carbide inserts. From the experimental research, 1.00% nAl2O3 nanofluids in coconut oil along with cutting speed of 87m/min and 0.14 mm/rev feed rate has proved the better machining performance to minimize the responses. Based on optical micrograph analysis, abrasion, adhesion and small BUE wear are three modes of wear mechanisms. Ribbon chips are produced with a different diameter, and curl diameter is increased with the increment of percentage concentration on turning of Inconel X-750.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
