Abstract
The FEM analysis of ultrasonic tool has been done in addition to surface roughness of machined samples using ultrasonic machining process have been presented. The experimental conditions were designed by using DOE approach. The analysis of results has been done using the MINITAB 14.0 software and results obtained are validated by conducting the confirmation experiments. The F-test and P-value has been applied to determine the significant parameters.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.