Abstract
The identification of fault locations (FL) on overhead power lines (OHPLs) in the shortest possible time allows for a reduction in the time to shut down OHPLs in case of damage. This helps to improve the reliability of power systems. FL devices on OHPLs according to the emergency mode parameters (EMPs) are widely used, as they have a lower cost. However, they have a larger error than FL devices that record traveling wave processes. Most well-known algorithms for FL on OHPL by EMP assume a uniform distribution of resistivity along the OHPL. In real conditions, this is not the case. The application of these algorithms in FL devices on OHPLs with inhomogeneities leads to significant errors in calculating the distance to the fault location. The use of search algorithms for unconditional one-dimensional optimization is proposed to increase the speed of the implementation of iterative procedures in FL devices on OHPLs by EMPs. Recommendations have been developed for choosing optimization criteria, as well as options for implementing computational procedures. Using the example of a two-sided FL on OHPL, it is shown that the use of search algorithms can significantly (from tens to hundreds of times) reduce the number of steps of the computational iterative procedure. The implementation of search algorithms is possible in the software of typical relay protection and automation terminals, without upgrading their hardware.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have