Abstract
Pressurized sample preparation devices (High Pressure Asher, Pressurized Microwave Digestion system, compared with a PTFE decomposition vessel) were used to dissolve certified metal alloy samples (steel, copper) for ICP analysis. Based on the results of the analysis it was established that both up-to-date devices can be advantageously applied to quickly and quantitatively dissolve metal alloy samples. To dissolve the samples, two different kinds of acid mixtures (A: nitric and hydrochloric acid; B: nitric and hydrochloric and sulphuric and phosphoric acid) were used. The sample preparation is simpler and less time-consuming than the earlier commonly used methods, sample loss and degree of contamination are also reduced. Steel samples containing tungsten, titanium and niobium (less than 0.5%) can only be analyzed using a mixture of the four acids. By dissolving steel samples in the nitric and hydrochloric acid mixture, the concentration of their most common elements (Cr, Ni, Mn, V, Cu) as well as their S and P content can be determined. Copper alloy samples can be dissolved quickly by the pressurized microwave decomposition device using hydrochloric acid and diluted (1:1) nitric acid.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
